![]() ![]() If it does not meet your expectations, you can use a flat-blade screwdriver to screw the lens to the bottom. Simply put the restricted inner thickness directly on the cutting platform. It is recommended to use an object with a fixed thickness and place a piece of gray cardboard on it to assist in adjusting the focus.ģ. Adjust the focus to a fixed height, refer to the picture above. Step 1: Adjust the bottom of the module and the cut honeycomb panel to a fixed height, refer to the picture above. ![]() The cutting and focusing methods are as follows:ġ. If it is mainly used for engraving, adjust the focus to a distance of 5 mm below the light barrier then slide the laser through a 5 mm spacer to use a fixed focus method If you use laserGRBL and lightburn software to adjust the focus, you need to enter a command: M3 S1 and give a motion command, for example: G0 x10 y10 f1000 so that low light can be lit NEJE software provides automatic low light.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |